As the market continues to change, the heat shrinkable film sleeve labeling machine is gradually being widely used. In the process of use, the common heat shrinkable film sleeve labeling machine is also encountered. Today, the following solutions are collected, and I hope to help you.
The reason why the shrink film is easy to accumulate in the center column:
poor shrink film;
The size of the shrink film does not match the design size of the center post;
The sleeve labeling machine is not adjusted.
Select a labeling machine with high stability, good adjustment and high tolerance to the shrinkage film size;
Shrink film quality into the factory control.
The reason for the label is not allowed to occur:
The sleeve labeling machine is not adjusted well;
The shrink film has static electricity.
Select a sleeve labeling machine with high stability, good adjustment and low static interference to the shrink film;
Strengthen the technical training of operators;
Use static elimination equipment.
The blade is easy to cut to the center post, causing the blade to break
The center column is not installed correctly;
The shrink film is accumulated in the center column.
Select a sleeve machine with high stability and shrink film that is not easy to accumulate in the center column;
Select the centering rod for easy installation and clamp the drive wheel to the center column. (Some brands of the labeling machine drive wheel can not clamp the center column, must be relaxed to a certain extent before the smooth labeling) If it is relaxed and not clamped, it will cause the position of the cutter and the center column to be incorrect.
The position of the shrink film is not flat, and there are reasons for the burrs:
The size of the shrink film is larger than the design size of the center column;
The tip is not sharp;
The blade level is incorrect.
Shrink film size control;
Replace the blade;
Use a good leveling machine with a good blade.